California Oversize Permits Phone Number - (972) 220-9831 ( DOT Trucks)
The California Vehicle Code requires an oversize load permit for any load exceeding legal weight or dimensions. Loads exceeding 14′ high, 8’6″ wide, 40′ long (single), 65′ (truck/trailer), 75′ (multi trailers), or 20,000 pounds axle require an oversize load permit.
The California Department of Transportation (Caltrans) issues special transportation permits for oversize/overweight vehicles on the State Highway System. The Caltrans Office of Commercial Vehicle Operations is responsible for the issuance of these special transportation permits. The permit may be obtained over the Internet at the Caltrans Single-Trip Application and Routing System 2 or by calling (916) 322-1297 during normal office hours.
California oversize permits Costs
The cost of California oversize permits varies depending on the type of permit. Here are the permit fees based on the search results:
– Single Trip Permit: $16 for a 7 consecutive days duration.
– Annual Permit: $90 for a one-year duration.
These are the two main types of permits available, with the single trip permit being valid for a specific trip and the annual permit being valid for a year. The fees are set by the California Department of Transportation and are applicable for oversize and overweight vehicles.
California Oversize Permits Requirements:
In California, oversize permits are issued by the California Department of Transportation (Caltrans) for vehicles and loads that exceed the maximum limitations specified in the California Vehicle Code. The permits are valid for seven days and are subject to specific operating times and restrictions.
Permit Types and Limits
Single Trip Permit:
Loads greater than 8′-6″ wide, 14′-0″ high, and over 80,000 pounds.
Annual Permit:
Loads up to 12′-0″ wide, 14′-0″ high, and Kingpin to Rear Axle (KPRA) 40′-0″ maximum (except as specifically allowed per CVC).
Repetitive Permit:
Loads up to 12′-0″ wide, 14′-6″ high, and 90′-0″ long.
Sea Container Permit:
4-Axle tractor and 3-Axle trailer of maximum Overall Length (OAL) of 65′-0″, and Kingpin to Rear Axle (KPRA) 40′-0″ maximum, transporting intermodal cargo containers on state highways in the vicinity of the Port of Los Angeles and the Port of Long Beach.
Variance Permit:
Vehicles greater than 15′-0″ wide, 17′-0″ high, and 135′-0″ long, or on special hauling equipment which exceeds the Department’s standard method of weight classification.
Restrictions and Conditions
Operating Times:
Continuous travel normally allowed if load does not require escorts, detours off of state routes, and does not exceed a two-vehicle configuration.
Night Travel:
Load must be lighted for night travel.
Restricted Travel:
Restricted times for loads over 10′ wide, Monday through Friday, and over 16′ (over 15′ on two-lane roads) also requires CHP escorts (three CHPs).
Height: Over 18′ requires one escort with high pole, utility clearance, and route survey.
Rear Overhang:
No rear overhang is allowed for loaded shipping containers, 5′ rear allowed for empties. Over height not permitted for shipping containers.
Escorts:
Escorts may be required for loads over 10′ wide, over 16′ (over 15′ on two-lane roads), and over 18′ in height.
Pilot Cars:
One pilot car is required for loads over 8′-6″ wide, over 80,000 pounds, or over 100′ overall length.
Signs and Lights:
Signs and flags are required on vehicles over 8′-6″ wide, over 80′ long, or with over 10′ overhang.
Weight:
Steer axle – 12,500 lbs, single axle – 20,000 lbs, tandem axle – 46,000 lbs (depending on axle spacings and routes), tridem axle – 58,061 to 60,000 lbs (depending on axle spacings and routes).
Fees and Fines
Permit Fees:
Single trip permits, annual permits, and repetitive permits have varying fees depending on the type of permit and the weight of the load.
Fines:
Maximum overweight fines can exceed $2,000.
Miscellaneous
Tridem Axles:
Spread axle tandem (8′ to 10′-2″ spread) can only have 40,000 lbs of weight.
Chain Laws:
Chain laws may apply during certain weather conditions.
CFT Permits:
California Fuel Trip (CFT) permits allow out-of-state registered owners to enter and travel into California for 4 consecutive days without obtaining a license for fuel tax purposes.
For more information and to apply for permits, contact the California Department of Transportation (Caltrans) at (916) 322-1297 or visit their website.
Minnesota Oversize Permit Cost:
Depending on the type of a permit, Minnesota oversize permits Cost might cost different amounts. The following are a few types of permits and the corresponding costs:
• Oversized and overweight single trips cost $15 in addition to a damage assessment fee.
• Oversized Multiple Trip: $36.
• Legal Overweight/Oversize: $36 + the Damage Assessment Fee times the estimated number of transfers.
• $120 is the annual permit fee for moving prefabricated homes and storage facilities.
• $200 is the annual fee for big loads that are not driven on the highway.
There’s also a Damage Assessment Fee, the amount of which can be determined using the Minnesota Department of Transportation’s Damage Assessment Fee Calculator.
A transportation permit from the county is also required if you need to transport an oversized load on the Anoka County Road system.
|
Length |
width |
height |
weight |
overhang |
|
53 feet |
8 feet 6 inches |
13 feet 6 inches |
80,000 pounds |
3 feet in the front and 4 feet in the rear. |
Minnesota Oversize Permits Requirement:
Permits for vehicles and loads exceeding specific weights and dimensions are needed in Minnesota. The following are minnesota oversize load regulations for permits:
Types of Permits and Fees:
Different permission kinds are available, each with a different charge depending on the load’s weight and size. These consist of annual, multi-trip, and single-trip permits, each with a different cost and set of specifications.
Minnesota Load Dimensions and Weights:
The load dimension requirements for mndot permits online vary depending on the type of permit. However, “Oversize Load” signs are required on the front and rear of the vehicle when the width exceeds 12 feet 6 inches and/or length exceeds 95 feet.
The legal dimensions for mn dot single trip permits are a width of 8 feet 6 inches, height of 13 feet 6 inches, and length of 75 feet. Loads exceeding these dimensions or weights are considered as mn dot Super Loads Permits. Escorts are required for loads over 95 feet long, over 14 feet 6 inches wide, or over 14 feet 3 inches high.
Minnesota maximum overweight permits limit:
|
Permits for single Axle Weight |
20,000 lbs. |
|
Permits for tandem Axles Weight |
40,000 lbs. |
|
Permits for Tridem Axles weight |
60,000 lbs. |
|
Permits for Quadem Axles weight |
72,000 lbs. |
|
Permits for five Axles weight |
92,000 lbs. |
|
Permits for six Axles weight |
112,000 lbs. |
|
Permits for seven Axles weight |
132,000 lbs. |
|
Permits for eight Axles weight |
144,000 lbs. |
Minnesota maximum overweight permits limit:
Depending on the size of the cargo, there are some travel limits that apply, such as prohibitions on holidays, weekends, and peak hours. For instance, certain permit classes restrict driving on interstate roads, and travel during holidays and rush hours is restricted.
Minnesota Escort Requirements:
• When the vehicle or load is more than 110 feet long, 15 feet broad at the bottom, or 16 feet wide at the top, a licensed rear escort is needed.
In cases where the vehicle or load is longer than 150 feet, certified front and rear escorts are necessary.
The Minnesota Pilot Car Escort Rules specify the particular criteria for pilot cars and escort vehicles when the load is over 14’6″ broad, 110′ long, or 16′ high.